suresh To configure EIGRP on a Cisco router using Packet Tracer, follow the steps below:
1. Access the router's command line interface by opening Packet Tracer and locating the router device.
2. Enter privileged EXEC mode by typing `enable` and then provide the password if prompted.
3. Access global configuration mode by typing `configure terminal`.
4. Enable the EIGRP routing process by typing `router eigrp [AS number]`, replacing [AS number] with the desired autonomous system number.
5. Configure the router's EIGRP router ID by typing `eigrp router-id [router-ID]`, where [router-ID] is the desired router ID.
6. Identify the network interfaces participating in EIGRP routing by typing `network [network address] [wildcard mask]`, replacing [network address] and [wildcard mask] with the appropriate values.
7. Optionally, configure EIGRP metric weights, authentication, summarization, and other parameters as needed.
8. Save the configuration by typing `write memory` or `copy running-config startup-config`.
9. Verify the EIGRP configuration by typing `show ip eigrp neighbors` to view neighboring routers.
By following these steps, you can successfully configure EIGRP on a Cisco router using Packet Tracer for efficient routing within your network.
Please login or Register to submit your answer